- IMG_3036 (1).jpg (43.18 KiB) Viewed 4210 times
The boat is temperature controlled to some extent, is in a wet slip and shrink wrapped, but has not been used for a few months (winter).
Thanks.
RE: Mold/Stain in Bow Question
Moderators: BeaconMarineBob, Moderator, BeaconMarineDon
RE: Mold/Stain in Bow Question
Found this mold (or stain?) in the bow under the berth on an 11 meter. Wondered if this is common and if anyone has ideas on the possible source and mitigation options. I could not find any obvious leaks above the berth, so am concerned it may be coming from below the berth or anchor well ( or elsewhere?)
The boat is temperature controlled to some extent, is in a wet slip and shrink wrapped, but has not been used for a few months (winter).
Thanks.
The boat is temperature controlled to some extent, is in a wet slip and shrink wrapped, but has not been used for a few months (winter).
Thanks.
-
RWS
- Ultimate User
- Posts: 2857
- Joined: Sat Feb 18, 2006 7:01 am
- Location: West Coast Florida
- Contact:
Re: RE: Mold/Stain in Bow Question
possible anchor locker drain stopped up with debris
RWS
RWS
1983 10 Meter SOLD after 21 years of adventures
Yanmar diesels
Solid Glass Hull
Woodless Stringers
Full Hull Liner
Survived Andrew Cat 5,Eye of Charley Cat 4, & Irma Cat 2
Trojan International Website: http://trojanboat.com/
WEBSITE & SITELOCK TOTALLY SELF FUNDED
Yanmar diesels
Solid Glass Hull
Woodless Stringers
Full Hull Liner
Survived Andrew Cat 5,Eye of Charley Cat 4, & Irma Cat 2
Trojan International Website: http://trojanboat.com/
WEBSITE & SITELOCK TOTALLY SELF FUNDED
Re: RE: Mold/Stain in Bow Question
agree on source. To clean, try Tilex (test in a hidden space) or soft scrub.
Motors should run. People -- not so much.
1980 F26, Mercruiser 305
1979 14' Starcraft, 1957 18 hp Evinrude and '57 3hp Evinrude kicker
1980 F26, Mercruiser 305
1979 14' Starcraft, 1957 18 hp Evinrude and '57 3hp Evinrude kicker